| |
| Items in Basket |
|
| Total (AUD) |
|
|
loading...
WIC-1B-S/T
Cisco 1 Port BRI S/T Wide Area Network Interface Card
Features
Data Sheet
Details
- One ISDN BRI port (S/T interface, requires external NT−1)
- RJ−45 connector
- Supported on Cisco 1600, 1720, 2600, 3600 or 3700 series
- Cannot be used with Cisco 1603 or 1604 base units
- Does not support hot swap, however no hardware damage occurs if it is swapped while power is on
- Can go into slot "W0" or "W1" of the 1E2W, 2E2W, and 1E1R2W
- Supported in NM−1FE1R2W, NM−1FE2W, NM−2FE2W, NM−2W
$20.00 AUD
In stock: 8
Qty
WIC-1T
Cisco 1 Port Serial Wide Area Network Interface Card
Features
Data Sheet
Details
* One serial port. * Uses the Cisco 60-pin "5-in-1" connector. This connector is DB-60 on one end and can be V.35, RS-232, RS-449, X.21 or EIE-530 on the other end depending on your needs * Uses the same cabling as Cisco 2500 and Cisco 7000 serial ports. * Does not support hot swap, however no hardware damage will occur if it is swapped while the power is on. * Each serial card has one LED, labeled CONN for each port, which lights when the serial port is connected. When the port is in data terminal equipment (DTE) mode, the CONN LED indicates that Data Set Ready (DSR), Data Carrier Detect (DCD), and Clear To Send (CTS) have been detected. When the port is in data communications equipment (DCE) mode, it indicates that Data Terminal Ready (DTR) and Request To Send (RTS) have been detected.
$20.00 AUD
In stock: 10
Qty
WIC-1SHDSL
Cisco 1 Port SHDSL Wide Area Network Interface Card
Features
Data Sheet
Details
* Symmetrical WAN speeds (up to 2.3 Mbps) over a single copper pair * Support for voice over IP (VoIP) over DSL with IP quality of service (QoS) * Support for IP QoS map to ATM class of service (CoS) * Back-to-back operation or operation via DSL access multiplexer (DSLAM) * Support for up to 23 virtual circuits per WIC
$50.00 AUD
In stock: 2
Qty
HWIC-1FE
Cisco 1 Port Fast Ethernet High Speed WAN Interface Card
Features
Data Sheet
Details
- Provides one standards-based 100BaseTX Fast Ethernet network interface
- Operates in half- and full-duplex modes
- Provides additional layer 3 routed interfaces
- Includes LED indicators that provide status information
This module is a refurbished product and comes with a 90 day hardware warranty.
$400.00 AUD
In stock: 2
Qty
HWIC-AP-G-A
Cisco 802.11b/g Wireless LAN Interface Card + 2 Antennas
Features
Data Sheet
Details
- Provides an integrated access point to select Cisco routers
- Extensive WLAN security capabilities
- Multiple VLAN support
- Includes LED indicators that provide status information
- 2 x AIR-ANT4941 2.4GHz Dipole Antennas included with HWIC
This module is a refurbished product and comes with a 90 day hardware warranty.
$160.00 AUD
In stock: 1
Qty
VIC2-2FXO
Cisco 2 Port Foreign Exchange Office Voice Interface Card
Features
Data Sheet
Details
- Connects local calls to a central office or PBX
- Supports Centralized
Automatic Message Accounting (CAMA) with software configuration
- Software-configurable for all regions
This module is a refurbished product and comes with a 90 day hardware warranty.
$150.00 AUD
In stock: 1
Qty
VIC2-4FXO
Cisco 4 Port Foreign Exchange Office Voice Interface Card
Features
Data Sheet
Details
- Connects local calls to a central office or PBX
- Supports Centralized
Automatic Message Accounting (CAMA) with software configuration
- Software-configurable for all regions
This module is a refurbished product and comes with a 90 day hardware warranty.
$210.00 AUD
In stock: 1
Qty
VWIC-1MFT-G703
Cisco 1-Port RJ-48 Multiflex Trunk E1 G.703
Features
Data Sheet
Details
- Supports voice and data applications
- RJ−45 connector
- Supported on Cisco 2600, 2800, 3600, 3700, and 38000 series
- Supports unframed G.703 and can be configured as a standard E1 interface
This module is a refurbished product and comes with a 90 day hardware warranty.
$60.00 AUD
In stock: 3
Qty
WIC-1AM
Cisco 1-Port Analog Modem WAN Interface Card
Features
Data Sheet
Details
- Interfaces support router management, dial backup, and access.
- includes a jack for handset sharing access to a PSTN line.
- Supported on Cisco 1700, 2600, 2600XM, 3600, and 3700
- 56 Kbps (V.90) can be achieved when the peer is a digital modem
This module is a refurbished product and comes with a 90 day hardware warranty.
$30.00 AUD
In stock: 9
Qty
WIC-2A/S
Cisco 2-Port Async/Sync WAN Interface Card
Features
Data Sheet
Details
- Provides data rates up to 128 Kbps synchronous or 115.2 Kbps asynchronous serial links
- Supported on the 1700, 2600 and 3600 Series routers
- Can support protocols such as PPP, Frame Relay and DTE/DCE
- Features dual smart serial interfaces
This module is a refurbished product and comes with a 90 day hardware warranty.
$35.00 AUD
In stock: 2
Qty
WIC-1B-S/T-V3
Cisco 1 Port BRI S/T V3 Wide Area Network Interface Card
Features
Data Sheet
Details
- One ISDN BRI port (S/T interface, requires external NT−1)
- RJ−45 connector
- Supported on Cisco 1700, 1800, 1900, 2600XM, 2800, 2900, 3700, 3800 and 3900 series routers
- Does not support hot swap, however no hardware damage occurs if it is swapped while power is on
- NM-1FE2W-V2, NM-2FE2W-V2, NM-1FE1R2W or NM-2W
$30.00 AUD
In stock: 1
Qty
WIC-1B-U-V2
Cisco 1 Port BRI U V2 Wide Area Network Interface Card
Features
Data Sheet
Details
- One ISDN BRI port (U interface, internal NT-1)
- RJ−45 connector
- Supported on Cisco 1700, 2600, 3600, 3700 series routers
- Does not support hot swap, however no hardware damage occurs if it is swapped while power is on
- Supported in NM-1FE1R2W, NM-1FE2W, NM-2FE2W, and NM-2W
$70.00 AUD
In stock: 2
Qty
HWIC-1ADSL
Cisco 1 Port ADSL High Speed WAN Interface Card
Features
Data Sheet
Details
- Provides one ADSL2/ADSL2+ wide area network interface
- Supports Dying Gasp function
- Supports IP quality of service (QoS)
- Has one RJ-11 ADSL interface
This module is a refurbished product and comes with a 90 day hardware warranty.
$300.00 AUD
In stock: 1
Qty
|
|